Enabling EC replication configuration on bucket

You can enable EC replication configuration at bucket level.

You can set the bucket level EC Replication configuration through CLI by running ozone sh bucket create <bucket path> --type EC --replication rs-6-3-1024k
To reset the EC Replication configuration,running ozone sh bucket set-replication-config <bucket path> --type EC --replication rs-3-2-1024k
note
- The new configuration applies only to the keys created after resetting the EC Replication configuration. Keys created before resetting the EC Replication configuration will have the older configuration.
- If you set EC Replication configuration on RATIS (while writing at a bucket level) and you are using Ozone File System (ofs/o3fs), there is a timeout of 10 minutes where you will continue to write on RATIS as a caching process in place at the bucket level. For fresh buckets, if you set EC Replication configuration on RATIS, the new configuration is immediately available for the bucket. However, for ofs/o3fs/s3 you can only use bucket level settings as you cannot allow EC setting on key creation.