Customizing Critical Hive Configurations
You receive property configuration guidelines, including which properties you need to reconfigure after upgrading. You understand which the upgrade process carries over from your old cluster to your new cluster.
The CDP upgrade process tries to preserve your Hive configuration property overrides. These
overrides are the custom values you set to configure Hive in the old CDH or HDP cluster. The
upgrade process does not perserve all overrides. For example, a custom value you set for
hive.exec.max.dynamic.partitions.pernode is preserved. In the case of other
properties, for example
hive.cbo.enable, the upgrade ignores any override and
just sets the CDP-recommended valued. Hive Configuration Requirements and Recommendations (link
below) indicates which overrides the upgrade process preserves or disregards (Safety Valve
The Apache Hive Wiki (link below) describes these properties. The values of these properties are lists.
The upgrade process ignores your old list and sets a new generic list. For example, the
hive.security.command.whitelist value is a list of security commands on the
whitelist. Any whitelist overrides you set in the old cluster are not preserved. If you
did not override whitelist values in the old cluster, you still need to check and change the new
default values in CDP. The new default is probably a shorter (more restrictive) list than the
original default you were using in the old cluster.
Check and change each property listed above after upgrading as described in the next topic.
Consider reconfiguring more property values than the six listed above. Even if you didn't override the default value in the old cluster, the CDP default might have changed in a way that impacts your work. Hive Configuration Changes (link below) lists the old CDH/HDP and new CDP defaults.