Hive
![[Important]](../common/images/admon/important.png) | Important |
|---|---|
You should not use the Hive CLI after enabling the Ranger Hive plugin. The Hive CLI is not supported in HDP-2.2.0 and higher versions, and may break the install or lead to other unpredictable behavior. Instead, you should use the HiveServer2 Beeline CLI. |
Use the following steps to enable the Ranger Hive plugin.
On the Ranger Configs page, select the Ranger Plugin tab.
Under Hive Ranger Plugin, select On, then click Save in the black menu bar.
A Save Configuration pop-up appears. Type in a note describing the changes you just made, then click Save.
A Dependent Configuration pop-up appears. Click OK to confirm the configuration updates.
Click OK on the Save Configuration Changes pop-up.
Select Hive in the navigation menu, then select Restart > Restart All Affected to restart the Hive service and load the new configuration.
Click Confirm Restart All on the confirmation pop-up to confirm the Hive restart.
After Hive restarts, the Ranger plugin for Hive will be enabled.